Ball mill Installation Steps

2020-07-13

Preparation

First of all, we must formulate the relevant installation plan and organize the relevant equipment. Check that the embedded bolts and elevation are consistent with the design drawings.

Secondly, the reference point and the corresponding central standard plate should be buried in accordance with the corresponding standard requirements. To strengthen the cleaning work of the equipment, it is necessary to remove the anti-rust oil and dust coated on the equipment.

Installation

1. Install the base of ball mill

Before installing the base, be sure to analyze the base of the ball mill in detail to check whether it meets the relevant design requirements. Observe whether the main bearing chassis of the ball mill is at the center line, and whether the coincidence degree exceeds 0.5mm, and the feed end should usually be about 1mm higher than the discharge end. In addition, after the elevation bolt is tightened, the theodolite can be used for chassis inspection to see if it is on the same horizontal line as the chassis.

2. Install the main bearings of ball mill
The installation process should ensure that the ball journal and bearings of the ball mill can run and have good contact performance. During the installation process, it is necessary to ensure that the two hollow shafts have the same axial degree, and the gap between the central shaft and the bearing should be controlled between 0.5mm and 1mm, and a certain degree of flexibility should be left on both sides of the free end.

Too tired to read? Try staff service!

Engineer one-to-one for you, draw up plans in time, and provide investment estimates in time!

Get Price Staff Service

Maybe You Want To Read

Raymond Mill Application In Limestone Production Line

How To Reduce Noise Of Vertical Roller Mill

Raymond Mill Common Faults And Solutions

Ball mill Installation Steps

Vertical Roller Mill Operation

Request a Quotation

Hot Sale